[ATTACH]411970[/ATTACH] I've used plans only to scratch build this RC aircraft. Here are the paper patterns for the fuselage bulkheads.
-
-
[ATTACH]411971[/ATTACH] The patterns were traced out onto three laminated sheets of 1/32nd balsa. -
[ATTACH]411972[/ATTACH] The half bulkhead which goes over the stab. The penned out area will be cut out after installation to make room for the stab.Comment
-
[ATTACH]411973[/ATTACH] The wing saddle bottom will also be cut out to properly fit the wing.Comment
-
[ATTACH]411974[/ATTACH] One half of the partially sheeted left side.Comment
-
[ATTACH]411975[/ATTACH] The fin sans rudder.Comment
-
[ATTACH]411976[/ATTACH] I used a scroll saw to cut out all the parts for this project.Comment
-
[ATTACH]411977[/ATTACH] Part of the wing. This is the center section containing the retractable main landing gear and engines.Comment
-
[ATTACH]411978[/ATTACH] The main landing gear from Robart.Comment
-
[ATTACH]411980[/ATTACH] Here is one of the flaps. Neatly faired in and even.Comment
-
[ATTACH]411981[/ATTACH] The flap hinged into the flap cove.Comment
-
[ATTACH]411982[/ATTACH] The framing of one of the four engine nacelles.Comment
-
[ATTACH]411983[/ATTACH] In a longitudinal position, the longeron wouldn't bend as easily. I just simply cut notches.Comment
-
[ATTACH]411984[/ATTACH] I used a method called 'strip planking'. Much like the old sailing ship's hulls.Comment
-
[ATTACH]411985[/ATTACH] You can see the edges are cut at an angle so they will interlock as they go around curved surfaces.Comment
Comment