Trumpeter 1/32 P40 F Warhawk

[Jim R]

Hi Barry
The camo painting looks great. I think Jakko was right about sharpening up along the colour edges. Decals do look nice as you say. Another wonderful model to add to the collection.
Jim

[adt70hk]

That's turned out very well indeed Barry.

Well done.

Andrew

[BarryW]

That's turned out very well indeed Barry.

Well done.

Andrew

Thanks but there is still a long way to go Andrew.

[BarryW]

There is something of a delay in progress.

after nursing that vulnerable tail wheel leg so far the model slipped in my hand and this...



There is no way to repair it and get it strong enough to hold.

I have therefore sourced a metal leg set for a Trumpy P40, not this particular kit. I will have to see how it can be fitted when it comes. I am hoping I will find a way to superglue it into place.

[outrunner]

Bad news, but it could have been worse, I remember dropping a model then slipping getting of the chair to pick it up and standing on the thing. Perhaps the parts could be joined with a small bit of brass tubing such as and old radio aerial.

Andy.

[BarryW]

The part is too thin Andy. Anyway a metal set is in the way.

[BarryW]

I have applied an enamel pin wash.

[BarryW]

I have done a Matt coat ready for further weathering.


I have to say that the two coats of acrylic gloss did not make the application of the ‘hot’ MRP Varnish any easier. It ate through the acrylic so I still had some remedial action to do.

With these MRP varnishes spraying as beautifully as they do I am determined to find a way to use them over lacquer paints without causing an issue. Just spraying those acrylic coats and the 48 hours they had to cure reminds me why MRP are so great. The series of mist coats I tried before is OK and an improvement over a simple wet coat but I still want to see if there is a better way.

[BarryW]

I have been getting g on with some weathering. Using AK Weathering Pencils, Uschi Metal Powders and AK washes and pigments.

[BarryW]

Some final fittings done including fitting the tail wheel. It was not difficult to do but it is not the strongest of fittings.


I should finish either later today or tomorrow.

[BarryW]

Finished

One quick pic and I will do a completed thread.

[Tim Marlow]

Nice job Barry. That’s a really sharp bird there.

[adt70hk]

Very nicely done by indeed Barry. Well done.

Andrew

[scottie3158]

Barry,
Nice job very neat.

[minitnkr]

A beauty. PaulE