If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Engine is done ......... and the bodywork is coming along, four coats of red gloss...... just needs a couple of coats of clear lacquer. Then I can mask it up for the black sections.
Thanks Ralph.
Thanks Ian, I'm quite chuffed with the red finish. Considering it was with a brush. A couple of coats of aerosol Lacquer should see it ok.
Even more impressive to say it's brush painted. Top work Peter and when the lacquer goes on and it's all shiny it will look even better.
Thanks Ralph.
Thanks Ian, I'm quite chuffed with the red finish. Considering it was with a brush. A couple of coats of aerosol Lacquer should see it ok.
It's had a couple of coats of clear gloss........... and "bugger" it's wrinkled some of the red in a couple of places. Not too drastic but I need to flat it down and repaint some. Ho hum.........
I'm going to have to try to get a replacement set of decals for this. They are breaking up wicked when I try to apply them. Not sure what's wrong with the buggers but they just sort of crumble. Never come across that before. I'm kind of stuck without them as there are some very long pinstripes for the bodywork and judging by the few small decals I've tried so far that isn't going to happen.
Thanks Ken. Not bad for a brush job. A bit of a crisis with the lacquer but I rescued it and it`s all shiny again...... I will be masking up for the black at the weekend........ I think that`'ll be a challenge.
Comment