If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Very impressive.
All 3D printed models are built up gradually in very thin layers,like stepped contours,and in the early days they were very evident and required a lot of fettling to remove. But nowadays they are so thin as to be almost undectable. There are a couple visible around the fin of the shark.
But it in no way was intended as a criticism, please don't take it that way.
Okay. Was not aware of this. I'm not a techy person. I'm not offended at all. I was just curious.
I'm not offended at all. 
I was just curious.
Comment