Stand problems

[Guest]

I have created a stand using a small table leg attached to a square block as a base.

The table leg is hollow and is around 32mm dia. This slots on to a small pipe on the model itself which is around 30mm.

The problem is that the model lists forward and I need to make it secure. I've tried to make the small pipe diameter bigger by using tape wrapped around, but the model is still listing forward.

Any suggestions? I can't really change the stand much now as it's wired in, but open to options.

[flyjoe180]

Can you fit ballast to the rear section of your model?

[Guest]

Good idea, but I've actually turned the part on the model sideways and now it's much better.