Need help with PE, its driving me nuts!!

[Guest]

Thank you very much Laurie

Cracking, will try the needles, i use old pringle lids for CA

Bob
[/QUOTE

The tatto needles idea I got from a friend. Most important, he told me, load needles on the full length (not dripping) lay needle full length on the PE & draw it along. "wot he told me".

Ps the needle end is made up of about 4 or 5 prongs. Very very slightly spray them apart.

Laurie

[BattleshipBob]

Well after a few hours of messing about with scrap pe, made into different size bits, and different amounts of CA. Finally a lot of progress. Followed Scotties advice and used a pointy end of a scaplel to lightly scratch the pe and contact area and tiny bit of CA


I hope you can see too very small, well for me they are!! PE bits, sounds daft but one happy bunny, i can tell you lol.

Thanks again for the excellent advice, what great support!!

[boatman]

I KNEW you would it boyo if you had a bit of practice well done

[JR]

Nice job Bob, just shows you can do it.