Need help guys, trying to damage a TKS in a fire fight with a Panzer I. Need to do bullet ricochets and one kill shot though the side of the TKS, any ideas?
-
-
For the ricochets and bullet strikes, I use a hot needle (held with pliers!) and lightly press against the plastic to make indents.Originally posted by \
For shell penetration same principle, but use something of the correct shell diameter such as a small screw driver or nail and push this right through the plastic.
I used this method on the tank in my 'Dead Elefant' album pictures if you fancy seeing the effect. No bullet strikes though!
I hope this has been of some use Jay.
Ron -
I'd check T'internet for shell strikes on armour as I've found all sorts of images there. As for bullet strikes I have seen plenty of pictures and (unfortunately,as a young boy in Biafra) plenty of the real thing and modellers almost invariably over do them. A typical rifle calibre machine gun round makes a hole about the same size as the round,not like in the movies! You are trying to make a hole,in your scale, of around 7-10mm diametre. A heavy machine gun still only makes a hole about 13mm diametre. At 1/48 an 8mm hole is less than 1/5 of a millimetre across!
Cheers
SteveComment
-
If you have a look through the gallery on this site there are a couple of shell deflections on page five to give you an idea of what they look like:
Tiger I Information Center | PanzerKampfwagen VI: The Legendary Tiger IComment
Comment