If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Just put all the parts together and it had this giant gab at the back of the warp nacelle. I couldn't test fit it because it would become stuck.
What do you guys think of this?
Is this already glued together? If so, then I suppose your only options are to either leave it like this, or use putty to close the gap, which you’ll need to scrape and/or sand down carefully. If it’s not glued yet, you could put plastic strip around the part to get rid of the gap.
Comment