VII/41C U-boat

[Guest]

Started on the wavy camo pattern. Have done a bit with the airbrush and with a bristle brush, a nice wash will blend it nicely I reckon.

Assembled the main gun, that was a little fiddly. The support arm for one of the seats snapped in half, thankfully the carpet monster didn't get it. so a bit of super glue later and all is well. Just needs to be cleaned up a little and given another lick of paint.

I have seen the photo etched pieces for the gun etc, to scared to work with PE to be honest.[ATTACH]98917.IPB[/ATTACH]

[ATTACH]98918.IPB[/ATTACH]

[Guest]

Ok...conning tower is coming along, most parts have been painted. Assembly is almost complete bar main gun on deck, machine guns and bits and bobs on the main deck[ATTACH]99400.IPB[/ATTACH]

[ATTACH]99401.IPB[/ATTACH]

[ATTACH]99402.IPB[/ATTACH]

[ATTACH]99403.IPB[/ATTACH]

[ATTACH]99404.IPB[/ATTACH]

[monica]

looking good,

[Guest]

[ATTACH]100779.IPB[/ATTACH]

So...after a week at work, which meant a week away from the model bench/table/cutting mat...I have managed to place the conning tower and its accoutrements, on the deck. Although not shown in this pic, the wires have been place on the fore section of the U-boat. Aft wires are being done at the moment.

Once these are in place, it will be clear coated, decal place upon it, coated again and then weathered.


Must also get around to painting the plinth!!!

[monica]

looking good,


will be looking forward to see some weathering on it,

[Guest]

Almost there!!!!


Buttoned up all the little bits that needed to be done. Tower fixed down, wires glued on etc.


Covered it with a few layers of Pledge Floor Wax (aka Klear). First time I have used this product...worked well. Didn't have any issues with it. Used it through my cheaper Chinese airbrush, just in case!!


U-boot smelt lovely too Left to dry for 24hrs.


Have given it a dark wash using "Flory Models Dark Wash"...just in the process of cleaning some of it off.


Will do a bit of rusting later, with MIG rust effect and various Tamiya Weathering Dusts.


Last bit will be to place the NASDAP Battle Flag/Ensign on the flag pole. The kit comes with a little paper version (no Swastika). But I have printed a proper Battle Flag on some paper, so will attach this.


Have aged a photo to give it that oldie look...but once its all done, i'll get the SLR camera out and get some nice shots...I hope


[ATTACH]101512.IPB[/ATTACH]

[spanner570]

Excellent work Andrew. I do like that last picture.


Waiting for the SLR "Nice shots"......

[Guest]

Just need somewhere to display it once it's done!!!!!!!

[monica]

very nice progress,and like Ron do like the last pic as well,